Magna-Safe

MAGNA-SAFE MSB
Mixers Bulletin 01-100
12/16/02
STORAGE

Do not remove protective coating until the agitator is to be put into service. If the shipment is to be stored, do not stack crates. Store in a clean dry indoor location which is free from wide variations in temperature. The storage area should be free from vibration and excessive heat.

At six-month intervals, inspect for external rust. Apply rust preventative as required. If the unit has been in storage for more than six months or subjected to adverse moisture conditions, the motor windings may have to be dried prior to operation.

Short-Term Indoor Storage

Agitators should be stored indoors in areas with no vibration and relatively constant temperatures and humidity. The factory storage preparations should be acceptable for up to six months storage.

Rotate the motor and gear drive shafts 10 to 15 revolutions at least once per month to reduce the possibility of brinelling of the bearings and to redistribute bearing grease.


Home		INSTALLATION, OPERATING, AND MAINTENANCE INSTRUCTIONS FOR MSB SERIES
Table of Contents 01-150 Initial Inspection 01-100 Storage MSB 01-125 Warranty 01-150 Field Service Rates 01-200 Bolt Tightening 02-050 Installation MSB 02-060 Mixer Positioning 03-100 Motor Lubrication 03-150 Gearbox Lubrication 03-190 Recommended Grease Table 04-050 Mixer Operation 04-100 Motor Operation 04-150 Gear Drive Operation 05-150 Maintenance Gear Drive MSB 06-050 Trouble Shooting Guide 07-050 Parts List MSB 07-060 Parts List MSB		MAGNA-SAFE MSB Mixers Bulletin 01-100 12/16/02 STORAGE Do not remove protective coating until the agitator is to be put into service. If the shipment is to be stored, do not stack crates. Store in a clean dry indoor location which is free from wide variations in temperature. The storage area should be free from vibration and excessive heat. At six-month intervals, inspect for external rust. Apply rust preventative as required. If the unit has been in storage for more than six months or subjected to adverse moisture conditions, the motor windings may have to be dried prior to operation. Short-Term Indoor Storage Agitators should be stored indoors in areas with no vibration and relatively constant temperatures and humidity. The factory storage preparations should be acceptable for up to six months storage. Rotate the motor and gear drive shafts 10 to 15 revolutions at least once per month to reduce the possibility of brinelling of the bearings and to redistribute bearing grease.